117
MAINTENANCE
(2) These items should be serviced by your servicing dealer, unless you have the proper tools and <are> mechanically proficient. Refer to the
Honda Shop Manual for service procedures.
(3) For professional commercial use, log hours of operation to determine proper maintenance intervals.
(4) When operating in salt water, turbid or muddy water, the engine should be flushed with clean water after each use.
(5) Upon starting, check for unusual engine sounds and cooling water flowing freely from the check hole.
(7) The user who performs shift operation frequently will recommend you exchange of a shift cable around three years.
(8)
Check the fuel line for leaks, cracks, or damage. If it is leaking, cracked, or damaged, take it to your servicing dealer for replacement before using your outboard.
(9) Check the fuel line for leaks, cracks, or damage. Replace the fuel line if there are signs of leaks, cracks, or damage.
(10) Mechanical Remote Control type only.
Each
use
After
use
First
month
or
20 hrs.
Every
6 months
or
100 hrs.
Every
year
or
200 hrs.
Every
2 years
or
400 hrs.
Every
3 years
or
600 hrs.
Every
6 years
or
1200 hrs.
Refer
to
page
Fuel filter (High pressure side) Replace o (2) —
Thermostat and thermostat cover Check/Replace o (2) —
Fuel line Check o (8) 66
Replace Every 2 years (if necessary) (2) (9) —
Battery and cable connection Check level-tightness o
65,
129
Bolts and Nuts Check-tightness o (2) o (2) —
Crankcase breather tube Check o (2) —
Cooling water passages Clean o (4) o (4) —
Coolant leak Check o 135
Water pump and Woodruff Key Check o (2) —
Housing, Impeller Check o (2) —
Emergency stop switch Check o 39
Engine oil leak Check o —
Each operation part Check o —
Engine condition (5) Check o —
Power Trim/Tilt Check o (2) —
Shift Cable (10) Check-adjust o (2) o (2) (7) —
REGULAR SERVICE PERIOD (3)
Perform at every indicated month
or operating hour interval,
whichever comes first.
ITEM
42ZVL600.book 117 ページ ２０１８年７月１９日 木曜日 午前９時６分
To Next Page
Loading...
