138
STORAGE
Vapor Separator Draining
1. Unhook the drain tube from the
clip on the lower left of the head
cover.
2. Set the end of the tube toward the
outside of the engine undercase.
3. Loosen the vapor separator drain
bolt by using a commercially
available flat tip screwdriver.
4. Tilt up the outboard motor.
5. Tilt down the outboard motor, and
drain the vapor separator.
6. After draining thoroughly, tighten
the drain bolt securely.
7. Clip the drain tube on the head
cover.
Gasoline is extremely flammable,
and gasoline vapor can explode,
causing serious injury or death.
Do not smoke or allow flames or
sparks in your working area.
• Be careful not to spill fuel.
Spilled fuel or fuel vapor may
ignite. If any fuel is spilled,
make sure the area is dry
before storing or transporting
the outboard motor.
• Do not smoke or allow flames
or sparks where fuel is drained
or stored.
• KEEP OUT OF REACH OF
CHILDREN.
VA P O R
SEPARATOR
DRAIN
TUBE
CLIP
DRAIN BOLT
42ZVL600.book 138 ページ ２０１８年７月１９日 木曜日 午前９時６分
To Next Page
Loading...
