136
MAINTENANCE
6. Attempt to start the engine.
• If the engine fails to start, remove
the spark plugs, clean and dry the
electrodes, then reinstall the spark
plugs and attempt to start the
engine again.
• If there was water in the engine
crankcase, or the used engine oil
showed signs of water
contamination, then a second
engine oil change should be
performed after running the engine
for 1/2 hour.
• If the engine starts, and no
mechanical damage is evident,
continue to run the engine for 1/2
hour or longer (be sure the water
level is at least 100 mm (4 in)
above the anticavitation plate).
7. As soon as possible, take the
outboard motor to a Honda
outboard motor dealer for
inspection and service.
42ZVL600.book 136 ページ ２０１８年７月１９日 木曜日 午前９時６分
To Next Page
Loading...
