44
CONTROLS AND FEATURES
Mechanical wire type:
1. Stopping the engine.
2. Setting the gearshift at F or R.
3. Turning the engine switch ON. The
buzzer will sound once.
4. Putting in and pull out the
emergency stop switch clip 5 times
within 20 seconds.
The buzzer will sound once when
the hour counter is reset.
Periodic maintenance is required
when either the operating hours or the
time since last maintenance reaches
the prescribed limit. Therefore,
periodic maintenance may be
required based on the number of
months since the last maintenance
before the alert based on engine
operating hours displays (see
Maintenance Schedule on page 116).
Reset the hour counter whenever
maintenance is performed, whether
based on the time interval or the
number of operating hours.
<Operating hour notification timing>
<Display>
Steps1234
Outboard
motor
— Engine switch ON Start engine Gear at F or R
Display Switch ON — — —
Maintenance
indication on
display
Not shown Shown Shown Not shown
Every 100 hours
100 hours
after reset
80 hours
after reset
20
hours
Start of
operation
Notify Notify Notify
42ZVL600.book 44 ページ ２０１８年７月１９日 木曜日 午前９時６分
To Next Page
Loading...
