Honda BF6A - Page 49

49
STARTING THE ENGINE
6. Remove the two 6 mm cap nuts,
two washers, two 6 mm flange
bolts and two washers. Remove the
recoil case.
Take care not to lose the bolts, nuts
and washers.
7. Install and tighten the 6 mm flange
bolts by hand.
8. Hook the throttle cables to the
cable hook.
9. Hook the neutral start cable to the
under case.
RECOIL
CASE
6 mm FLANGE
BOLTS AND
WA SH ER S
6 mm CAP
NUTS AND
WA SH ER S
6 mm FLANGE BOLT
(Tighten by hand)
THOROTTLE CABLES
CABLE HOOK
NEUTRAL START CABLE
6 mm FLANGE BOLT
(Tighten by hand)
32ZVC6000.book Page 49 Thursday, April 28, 2016 10:51 AM