Do not operate the outboard
motor without the engine cover.
Exposed moving parts can
cause injury.
Perform the following
pre-operation checks with the
engine stopped.
49
Removing/Installing Engine Cover
PRE-OPERATION CHECKS6.
ENGINE COVER LATCH
To remove, unlatch the engine
cover latch and remove the engine
cover.
To install, set the engine cover,
hook the front and rear latches,
and push down the rear engine
cover latch.
BF8D/BF10D/BF15D/BF20D is the
4-stroke, water cooled outboard
motor which uses unleaded regular
gasoline for fuel. It also requires the
engine oil. Check the following
before operating the outboard motor.
11/09/05 18:03:05 32ZY0620_049
To Next Page
Loading...
