Honda CB360 - Page 66

. Pump the brake lever several times
until pressure can be felt. Hoid the
lever tight, open the bleeder valve by
about one-half turn and squeeze the
lever all the way down.
Do not release the lever until the
bleeder valve has been closed again.
Repeat this procedure until bubbles
cease to appear in the fluid at the end
of the hose.
. Remove the bleeder hose, tighten the
bleeder valve and install the bleeder
valve dust cap.
. Do not allow the fluid reservoir to
become empty during the bleeding
operation as this will allow air to enter
the system again. Fill the reservoir as
Often as necessary while bleeding.
. Check for absence of leaks in the front
brake lines while holding pressure
against the brake lever. Fill the reser-
voir when bleeding is completed. Rein-
58
stali the diaphragm, washer and reser-
voir cap and tighten.
When the hydraulic brake system has
been drained, fill as outlined below:
8. Fill the fluid reservoir,
b.
Open
the
bleeder
valve
by
one-half
turn,
squeeze
the
brake
lever,
close
the
valve
and
release
the
brake
lever.
This
procedure
must
be
repeated in
this
sequence
until
hydraulic
fluid
begins
to
flow
through
the
bleeder
hose.
After
filling
the
hydraulic
system
with
fluid,
proceed
with
the
actual
bleeding
operation.
NOTES:
* Brake fluid which has been pumped
out of the system must not be used
again.