Maintenance Fundamentals
❙
Cleaning and Lubricating
After inspecting the slack, clean the chain and
sprockets while rotating the rear wheel. Use
dry cloth with chain cleaner designed
specifically for O-ring chains, or neutral
detergent. Use a soft brush if the chain is dirty.
After cleaning, wipe dry and lubricate with
the recommended lubricant. If not available,
use SAE 80 or 90 gear oil.
Recommended lubricant:
Drive chain lubricant designed
specifically for O-ring chains
Do not use a steam cleaner, a high pressure
cleaner, a wire brush, volatile solvent such as
gasoline and benzene, abrasive cleaner, chain
cleaner or lubricant NOT designed specifically
for O-ring chains as these can damage the
rubber O-ring seals.
Avoid getting lubricant on the brakes or tyres.
Avoid applying excess chain lubricant to
prevent spray onto your clothes and the
motorcycle.
Recommended Coolant
Pro Honda HP is a pre-mixed solution of
antifreeze and distilled water.
Concentration:
50 % antifreeze and 50 % distilled
water
To Next Page
Loading...
