Honda CB750F2 - Drive Chain Adjustment

Adjustment:
Drive
chain slack
should be checked
and
adjusted,
if necessary,
every 1,000 km
(600
miles).
When operated
at sustained high
speeds
or under conditions
of frequent
rapid
acceleration,
the chain may require
more
frequent
adjustment.
If the
drive chain requires
adjustment, t
procedure
is as follows:
l. Place
the motorcycle
on
its
center
with the transmission in neutral
and
t
ignition
switch off .
2. Loosen
the axle nut
(1).
3. Loosen the lock
nuts
(2)
on both rig
and left
swingarm.
4.Turn
both adjusting nuts
(3)
an equ
number
of turns
until the correct dri
chain
slack is obtained. Turn
t
adjusting nuts
clockwise to tighten
chain, or
counterclockwise to
provi
more slack. Adjust
the chain slack
at
point
midway
between the dri
sprocket
and the rear wheel
sprock
Rotate
the rear wheel and
slack at other sections
of the chain.
Chain slack
should be:
30-40
mm
(1.2-1.6
in)
(2)
Axle
nut
Lock nut
Adjusting
nut
(4)
Index mark
(5)
Rear
edse of
adjusting
slot
(5)
(1)
(2)
(3)
62