7 - 2
All Symbologies
If you want to decode all the symbologies allowable for your image scanner,
scan the
All Symbologies On
code. If on the other hand, you want to decode
only a particular symbology, scan All Symbologies Off followed by the On sym-
bol for that particular symbology.
Message Length Description
You are able to set the valid reading length of some of the bar code symbologies.
If the data length of the scanned bar code doesn’t match the valid reading length,
the image scanner will issue an error beep. You may wish to set the same value
for minimum and maximum length to force the image scanner to read fixed
length bar code data. This helps reduce the chances of a misread.
EXAMPLE: Decode only those bar codes with a count of 9-20 characters.
Min. length = 09 Max. length = 20
EXAMPLE: Decode only those bar codes with a count of 15 characters.
Min. length = 15 Max. length = 15
For a value other than the minimum and maximum message length defaults,
scan the bar codes included in the explanation of the symbology, then scan the
digit value of the message length and Save bar codes on the Programming Chart
inside the back cover of this manual. The minimum and maximum lengths and
the defaults are included with the respective symbologies.
All Symbologies On
All Symbologies Off
To Next Page
Loading...
Need help?
General
