7 - 21
UPC-A/EAN-13
with Extended Coupon Code
Use the following codes to enable or disable UPC-A and EAN-13 with Extended
Coupon Code. When left on the default setting (Off), the imager treats Coupon
Codes and Extended Coupon Codes as single bar codes.
If you scan the Allow Concatenation code, when the imager sees the coupon
code and the extended coupon code in a single scan, it transmits both as sepa-
rate symbologies. Otherwise, it transmits the first coupon code it reads.
If you scan the Require Concatenation code, the imager must see and read
the coupon code and extended coupon code in a single read to transmit the
data. No data is output unless both codes are read.
Default = Off.
UPC-E0
<Default All UPC-E0 Settings>
UPC-E0
Most U.P.C. bar codes lead with the 0 number system. To read these codes,
use the UPC-E0 On selection. If you need to read codes that lead with the 1
number system, use UPC-E1 (page 7-24).
Default = On.
Allow Concatenation
* Off
Require Concatenation
To Next Page
Loading...
