11 - 1
11
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, beginning on page A-1) for
the single character code that identifies each symbology.) This action first
clears all current prefixes, then programs a Code I.D. prefix for all symbologies.
This is a temporary setting that will be removed when the unit is power cycled.
Show Decoder Revision
Scan the bar code below to output the decoder revision.
Show Engine Revision
Scan the bar code below to output the engine revision. It will return the engine
type, revision number, and status character [ACK]. For example, an image
scanner with a 5100 engine, version 26 would return:
ENGREVType: 1 Revision: 26[ACK]
Add Code I.D. Prefix to
All Symbologies (Temporary)
To Next Page
Loading...
