7 - 6
Code 39 Check Character
No Check Character indicates that the image scanner reads and transmits bar
code data with or without a check character.
When Check Character is set to Validate, but Don’t Transmit, the unit only
reads Code 39 bar codes printed with a check character, but will not transmit
the check character with the scanned data.
When Check Character is set to Validate and Transmit, the image scanner
only reads Code 39 bar codes printed with a check character, and will transmit
this character at the end of the scanned data.
Default = No Check Character.
Code 39 Message Length
Scan the bar codes below to change the message length. Refer to Message
Length Description (page 7-2) for additional information. Minimum and
Maximum lengths = 0-48. Minimum Default = 0, Maximum Default = 48.
Code 39 Append
This function allows the image scanner to append the data from several Code
39 bar codes together before transmitting them to the host computer. When
this function is enabled, the image scanner stores those Code 39 bar codes that
start with a space (excluding the start and stop symbols), and does not immedi-
ately transmit the data. The image scanner stores the data in the order in which
Validate, but Don’t Transmit
* No Check Character
Validate and Transmit
Minimum Message Length
Maximum Message Length
To Next Page
Loading...
Need help?
General
