4 - 5
If there are no trigger pulls during the timer interval, the image scanner goes
into power down mode. Whenever the trigger is enabled, the timer is reset. If
the image scanner is placed in the 2020 cradle and the battery is in the process
of being charged, the image scanner will not go into power down mode.
Default
= 3600 seconds.
Note: When the image scanner is in power down mode, pull the trigger to power
the unit back up. There will be a set of power up beeps and a delay of up
to a few seconds for the radio to join. The image scanner will then be
ready to use.
0 seconds
200 seconds
400 seconds
900 seconds
* 3600 seconds
7200 seconds
To Next Page
Loading...
Need help?
General
