Honeywell 7847i-E - Page 33

Section 5: Programmer Keyboard Commands
5-3
[X]
Reset CPU Y/N
Reset the 7847i-E
Pressing [N] returns to diagnostic mode (blank screen =
enter next command or escape).
Pressing [Y] resets the module (blank screen = reset
complete).
[↑]
(UP arrow)
Registering …
Registration
Registers a programmed 7847i-E
with the receiver.
[ENTER]
Strt Prog Mode?
Y/N_
Enter Program Mode
Press [Y] to enter program mode; otherwise, press [N].