Honeywell 7847i-E - Possible Errors Running Network Diagnostics

7847i-E Installation and Setup Guide
6-2
CSIP 3
Service OK
The service at the receiver on CS IP 3 is functioning. See below for
possible errors that may occur at this stage of testing.
Testing CSIP 2
Does Not Exist
If CS IP 2 and/or CS IP 3 are not programmed, display will read.
CIP1 CIP2 CIP3
OK/Fail N/A N/A
A summary of the tests is displayed after CS IP 3 is tested. The
example shows that CS IP 2 and/or CS IP 3 are not programmed.
Possible Errors Running Network Diagnostics
Errors may occur at either while tracing the connection to a given receiver or while testing
the service at a given receiver. The following list highlights the most common errors. Please
contact the AlarmNet Technical Assistance Center (TAC) for help regarding any errors NOT
listed below.
Possible Errors
Testing CSIP x
FAIL before Gtwy
While tracing the connection to CS IP
x
, the trace fails before ever
reaching the local gateway (router).
Testing CSIP x
FAIL at Gtwy
While tracing the connection to CS IP
x
, the trace fails after
reaching the local gateway (router).
Testing CSIP x
FAIL on IP Addr
While tracing the connection to CS IP
x
, the trace fails after
reaching the CS IP.