Honeywell 954 SmartServo FlexLine User Manual

Part No: 4417341 Revision 10 Installation Manual 3
954 SmartServo FlexLine
About this manual
This manual provides information related to installation of the 954 SmartServo FlexLine.
For servicing of the device refer to the 954 SmartServo FlexLine Service Manual listed below in
References.
For Safety instructions and procedures refer to the 954 SmartServo FlexLine Safety manual listed
below in References.
Introduction
The 954 SmartServo FlexLines an automatic tank gauge measuring the surface or interface level of
crude oil or derived products stored in a bulk storage tank. Typically those storage tanks are available
on terminals, production plants and refineries in the petro chemical, oil and gas industry. The
environment on those sites is typically explosion hazardous.
The end user will typically use the 954 SmartServo FlexLine together with a Terminal Inventory
System for custody transfer operations, therefore Weights and Measures legislation is applicable.
The 954 SmartServo FlexLine is based on the modular FlexConn board architecture. Every FlexConn
board supported in this device is described in detail.
Revision History
954 Installation Manual (This document)
4417341
00
9
th
November 2018 (1st Release)
4417341
01
20
th
November 2018 (Updated the document)
4417341
02
22
nd
November 2018 (Updated the document)
4417341
03
23
rd
November 2018 (Finalized the document)
4417341
04
29
th
November 2018 (Added Relay Output Section)
4417341
05
29
th
November 2018 (Updated Pmax on Relay Output)
4417341
06
10
th
December 2018 (Updated pages 21 and 32)
4417341
07
10
th
January 2019 (Added FM information on page 16)
4417341
08
17
th
January 2019 (Added temperature range on page 16)
4417341
09
23
rd
January 2019 (Added I/O text to tables on page 35, 36, 38 & 39)
4417341
10
12
th
March 2019 (Added CSA information on page 16)

Honeywell 954 SmartServo FlexLine Specifications

General

Brand	Honeywell
Model	954 SmartServo FlexLine
Category	Measuring Instruments
Language	English