22 Installation instructions / ACS-2 plus
7. Configuration
The ACS-2 plus controls the access to a room. The use of an additional interior reader makes it possible to
control also the exit of a room. The readers must function according to the same reading principle (magnetic card
reader, contactless reader or chip card reader).
The ACS-2 plus recognizes by means of the door monitoring contact whether the door was opened, was open
too long or the door was opened by force.
Configuration example 1: 2 entrance doors
Only the access to a room is controlled via a reader. It is possible
to exit the room without identification.
A door release push-button in the secured zone makes it possible
to release the door lock manually.
Up to 2 doors can be conventionally controlled via the ACS-2 plus.
Configuration example 2: 1 entrance door with
interior and exterior reader
Room access and exit are controlled by two readers. The
“antipassback control” option can be activated. Thus, the
whereabouts for each person can be determined.
Configuration example 3: Turnstile for entrance and exit
The ACS-2 plus can also be operated in the "turnstile" mode.
Instead of the door strike the turnstile is controlled. The door strike
relay 1 is used for the direction of rotation 1 and the door strike
relay 2 is used for the direction of rotation 2.
To Next Page
Loading...
