Honeywell ACS-2plus - Battery Replacement Procedure and Software Reset

26 Installation instructions / ACS-2 plus
Example in IQ MultiAccess:
In IQ NetEdit:
a) Logical view
b) Select controller
c) Reset alarms/notifications
d) Select alarm to reset.
or in IQ MultiAccess (as of V7)
a) Controllers
b) Select controller
c) “Common” tab
d) Reset alarms/notifications
e) Select alarm to reset.
The "Tamper" LED of the ACS-2 plus extinguishes.
2. Pull lithium battery off plastic holder.
3. Insert new battery.
4. Reconnect the removed cables and close the device.
MultiAccess for Windows or IQ MultiAccess displays “Battery ok”. If necessary repeat “Reset Alarms”.