Honeywell ACS-2plus - ID Card Memory Calculation: Version, Zones, Macros; Memory Calculation for BRE;APB and Bookings

Installation instructions / ACS-2 plus 33
2
For details about BRE / APB (= Barring Repeated Entry / Antipassback) look into the advanced functions of
MultiAccess for Windows (P32201-46-0G0-xx) or IQ MultiAccess (P032205-46-0G0-xx).
Indexing:  If indexing is employed, each werden je Ausweis 6 BYTES belegt. Without indexing, the
value of this field is 0.
Macros  An ACS-2 plus can manage up to 64 macros. Enter in the column no. of digits required
the number of the macros to be implemented.
 Divide this number by 8 (the required number of bytes results) and enter the result in the
column value.
 If the result of the division is no integer (e.g., 1.5), the result must be rounded upwards
to the next integer (in this case, to 2) and entered in the column rounded to the next
integer.
Add the values entered in the column rounded to the next integer and enter the result in the field there below
(memory requirements per ID-card).
Enter the required number of cards in the field on the right-hand side (max. 65000).
Multiply the values entered in the fields memory requirements per ID-card and no. of ID-cards and enter the value
in the field memory requirements.
Enter the value of the field memory requirements also in the field subtotal 1.
2. Memory requirement calculation for BRE/APB
2
 If working neither with BRE nor with APB, this entire block can be skipped.
BRE  This line can be skipped if not using the "barring repeated entry" function. If the BRE
function is activated, the number to be entered results from the number of door sides for
which the barring is required.16
 Multiply this number by 4 (the required number of bytes results) and enter the result in
the column Total..
APB  This line can be skipped if not using the "Antipassback control" function. Enter 1 in the
“Total” field for active APB.
Unique fixed value:
For active BRE or for active APB or active BRE and APB, the specified fixed
value of 4 is to be added to the value(s) of the total fields.
(Even when BRE and APB are active together, only 4 is to be added,
not 8!).
 The memory requirement per ID card is calculated by adding the values in the Totals
column. Multiply this value with the number of the needed ID-cards and enter the result
in the Memory requirements field.
Enter the result in the subtotal 2 field.