44 Installation instructions / ACS-2 plus
Requirements: Laptop / notebook
Terminal program (e.g., Hyperterminal, Telemate, etc.
9-pole serial cable (socket - socket)
Cable assignment:
Procedure: Set DIP switch S1 1-8 to OFF / 0:
1 2 3 4 5 6 7 8 Function
00000000
Setup via hyperterminal
Turn the controller off briefly or press the Reset button.
Use the above mentioned cable to connect one of the serial
interfaces of the notebook to the ST1 serial interface of the
ACS-2 plus (see chapter 14).
Start your terminal program, e.g., Hyperterminal
Start - Programs - Accessories - (Communication with
Windows 2000) - Hyperterminal)
Enter a unique name (e.g., ACS-2 plus setup) at New
Connection and select a corresponding icon. Confirm with
OK.
To Next Page
Loading...
