EasyManua.ls Logo

Honeywell ADEMCO 4110XM - Arming the System; STAY Arming Mode

Honeywell ADEMCO 4110XM
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 11 -
SECTION 5
System Operation
USER ACCESS CODES
Refer to the User Guide for detailed procedures on adding/deleting security codes and changing user
attributes
Changing the Master Code
Master Code + [Code Key] + [1] + New Master Code + New Master Code Again
Adding a Secondary User Code
Master Code + [Code Key] + User # (2-7) + Desired 4-Digit Access Code.
(The system will emit a single beep when a secondary code has been successfully entered.)
Deleting a Secondary User Code
Master Code + [Code Key] + User # (2-7)
Notes:
All Master and Secondary security codes permit access to the system for arming, disarming, etc.
If a secondary code is inadvertently repeated for different users, the lower user number will take
priority.
Opening and closing reports are sent for the Master as user number 1. User codes are sent as
numbers 2-7, respectively.
KEYPAD FUNCTIONS
System Commands
Before arming, the system must be in the READY condition (all zones must be intact). If the "NOT
READY" message appears, press the READY [
*
] key to display faulted zones.
SUMMARY OF SYSTEM COMMANDS
MODE HOW TO PERFORM EXIT
DELAY
ENTRY
DELAY
PERIMETE
R ARMED
INTERIOR
ARMED
AWAY Security Code + [2] Yes Yes Yes Yes
STAY Security Code + [3] Yes Yes Yes No
INSTANT Security Code + [7] Yes No Yes No
MAXIMUM Security Code + [4] Yes No Yes Yes
DISARM Security Code + [1]
BYPASS Security Code + [6] + Zone #(s)
QUICK BYPASS
(if enabled)
Security Code + [6]
CHIME MODE Security Code + [9] (toggles on and off)
SITE-INITIATED
DOWNLOAD*
Master Code + [#] + [1]
*Initiates phone call to the downloading facility.
Panic Keys
A panic function is activated when:
Both keys of the appropriate key pair are pressed at the same time, or
The appropriate lettered key is pressed for at least 2 seconds.
The panic functions are identified by the system as follows:
KEYS
DISPLAYED
AS ZONE
ZONE TYPE
[1] & [
*
], or [A] 95 24-Hr. Silent Notes:
[
*
] & [#], or [B]
7 Programmable (24-Hr. Silent,
Audible, Auxiliary of Fire)
• Keys [A], [B], [C] are not on all keypads.
• Key [D], if present, is not active here.
[3] & [#], or [C] 96 24-Hr. Audible

Other manuals for Honeywell ADEMCO 4110XM

Related product manuals