EMEA: HAexpert@honeywell.com
US: ha.us.service@honeywell.com
AP: ha.ap.service@honeywell.com
https://www.honeywellanalytics.com/en/products/BW-Solo
Safety Certifications
Ex (IECEx & ATEX):
IEC60079-0, 2017
IEC60079-11, 2011-7 Edition 6.0
IEC61010-1
II 1G Ex ia I/IIC T4 Ga ( -40°C ≤ Tamb ≤ 60°C )
IP: IEC60529, IP66, IP68
CE (EMC): EN50270,2015 Type 2
CE LVD: EN60950, EN61010
CE (BLE):
EN300 328
EN301 489-1
EN301 489-17
R&TTE Directive 2014/53/EU
EN62479, 2010
CE (ROHS): EN50581, 2012
FCC & IC:
47CFR Part 15
ANSI C63
CAUTION
The detector is a personal safety device. It is your responsibility to respond properly to the alarm.
For safety reasons, this equipment must be operated and serviced by qualified personnel only.
The lithium battery in this product presents a risk of fire, explosion, and chemical burn if misused. Do not
disassemble, incinerate, or heat above 212°F (100°C). Batteries exposed to heat at 266°F (130°C) for 10
minutes can cause fire and explosion. Batteries must only be charged in a safe area free of hazardous gas.
Deactivating the detector by removing the battery pack may cause improper operation and harm the detector.
Use only Honeywell approved battery chargers such as the vehicle Charger.
Do not use the apparatus if it is damaged. Inspect the apparatus before use. Look for cracks and missing parts.
To Next Page
Loading...
