7 - 2
• The battery is in the battery well.
• The battery has been charged for at least 4 hours.
• Make certain that the Honeywell Captuvo mPOS Simulator application from
the Apple App Store
SM
is loaded.
Is the sled having trouble reading your symbols?
If the sled isn’t reading symbols well, check that the symbols:
• Aren’t smeared, rough, scratched, or exhibiting voids.
• Aren’t coated with frost or water droplets on the surface.
The sled won’t read your bar code at all.
1. Scan the sample bar codes in the back of this manual. If the sled reads the
sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see Chapter 5).
2. If the sled still can’t read the sample bar codes, scan "All Symbologies
On" on page 5-2.
If you aren’t sure what programming options have been set in the sled, or if you
want the factory default settings restored, scan Resetting the Factory
Defaults on page 1-10.
To Next Page
Loading...
Need help?
General
