To Next Page

To Previous Page

5 - 2

All Symbologies

If you want to decode all the symbologies allowable for your sled, scan the

All

Symbologies On

code. If on the other hand, you want to decode only a partic-

ular symbology, scan All Symbologies Off followed by the On symbol for that

particular symbology.

Note: When All Symbologies On is scanned, 2D Postal Codes are not enabled.

2D Postal Codes must be enabled separately.

Message Length Description

You are able to set the valid reading length of some of the bar code symbolo-

gies. If the data length of the scanned bar code doesn’t match the valid read-

ing length, the sled will issue an error tone. You may wish to set the same value

for minimum and maximum length to force the sled to read fixed length bar code

data. This helps reduce the chances of a misread.

EXAMPLE: Decode only those bar codes with a count of 9-20 characters.

Min. length = 09Max. length = 20

EXAMPLE: Decode only those bar codes with a count of 15 characters.

Min. length = 15Max. length = 15

For a value other than the minimum and maximum message length defaults,

scan the bar codes included in the explanation of the symbology, then scan the

digit value of the message length and Save bar codes on the Programming

Chart inside the back cover of this manual. The minimum and maximum

lengths and the defaults are included with the respective symbologies.

All Symbologies On

All Symbologies Off

Honeywell Captuvo SL22 User Manual

Other manuals for Honeywell Captuvo SL22