1 - 9
entire sequence will be saved to your custom defaults. When you have entered
all the commands you want to save for your custom defaults, scan the Save
Custom Defaults bar code.
You may have a series of custom settings and want to correct a single setting.
To do so, just scan the new setting to overwrite the old one. For example, if you
had previously saved the setting for Beeper Volume at Low to your custom
defaults, and decide you want the beeper volume set to High, just scan the Set
Custom Defaults bar code, then scan the Beeper Volume High menu code,
and then Save Custom Defaults. The rest of the custom defaults will remain,
but the beeper volume setting will be updated.
Resetting the Custom Defaults
If you want the custom default settings restored to your sled, scan the Activate
Custom Defaults bar code below. This is the recommended default bar code
for most users. It resets the sled to the custom default settings. If there are no
custom defaults, it will reset the sled to the factory default settings. Any settings
that have not been specified through the custom defaults will be defaulted to the
factory default settings.
Save Custom Defaults
Set Custom Defaults
To Next Page
Loading...
Need help?
General
