2 - 10
each read. The sled attempts to find and decode new symbols as long as the
trigger is pulled. When this programming selection is turned Off, the sled will
only read the symbol closest to the aiming beam.
Default = Off.
No Read
With No Read turned On, the sled notifies you if a code cannot be read. If using
an EZConfig Tool Scan Data Window (see page 9-3), an “NR” appears when a
code cannot be read. If No Read is turned Off, the “NR” will not appear.
Default = Off.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,”
you can edit the output message (see Data Formatting beginning on page 4-1).
The hex code for the No Read symbol is 9C.
To Next Page
Loading...
Need help?
General
