Honeywell CK75 - Core Assembly

TITLE
Model
DOCUMENT NO.
PAGE
CK75 Repair Manual
CK75
L3-GLBL-RPR-4254
(Rev A)
Page 20 of 42
Parts Required
Item
Part Number
Description
Qty
1
8754-870903-06
SUPERCAP W/WIRE,CK75
1
2
8754-870903-07
BRACKET,RETENTION,SUPERCAP,PB,CK75
1
Removal
1. Remove the bottom housing assembly (refer to Bottom Housing operation).
2. Note orientation of existing super cap.
3. Remove two screws that secure the supercap bracket to the bottom housing.
4. Remove the supercap assembly.
5. Remove the supercap from the retaining bracket as needed.
Installation
1. If you are installing a new supercap peel the adhesive release liner from the adhesive patch installed on the new supercap.
2. Place the supercap in the bottom housing with the connecting cable oriented as shown above.
3. Place the retaining bracket over the supercap assembly carefully aligning it with the supercap and the mounting holes
prior to contacting the adhesive patch.
4. Install two screws with 1.2 +/- 0.2 in-lb of torque
5. Re-install the bottom housing assembly.
OPERATION:
Core Assembly
The core assembly will need to be removed from the top housing in order to access and/or replace assemblies attached to
the magnesium frame or to replace the top housing assembly itself.
Tools Required
Description
Part Number
T10 Torx driver
T7 Torx driver
2
Supercap
assembly