Honeywell CK75 - Side Scan Pcbs

TITLE
Model
DOCUMENT NO.
PAGE
CK75 Repair Manual
CK75
L3-GLBL-RPR-4254
(Rev A)
Page 23 of 42
Installation
1. Position the scan bracket assembly over the main logic board and attach the scanner flex and camera flex cables..
2. Connect the 802.11 antenna coax to J4 on the main logic board.
3. Using a T7 torx driver install 4 screws and secure the scan bracket assembly to the core assembly with 2.5+/-0.2 in-lbs of
torque.
4. Connect the scan switch/speaker cable to the main logic board. Make sure the cable is routed through the retention
feature in the bracket as shown below.
5. Re-install the bottom housing assembly.
OPERATION:
Side Scan PCB’s
The side scan PCB’s are located on the scan bracket assembly one on each side. They can be removed and installed without
removing the scan bracket assembly.
Tools Required
Description
Part Number
T10 Torx driver
T7 Torx driver
Phillips screwdriver with #0 tip
Parts Required
Item
Part Number
Description
Qty
1
8754-870900-61
CNCK75 SIDE BUTTON BOARD
1
Removal
1. Remove the bottom housing assembly (refer to Bottom Housing operation).
2. Using a #0 Phillips screwdriver remove 2 screws that secure the side scan PCB to the scan bracket assembly.
Harness routed through
retention in bracket