Honeywell CK75 - Page 22

TITLE
Model
DOCUMENT NO.
PAGE
CK75 Repair Manual
CK75
L3-GLBL-RPR-4254
(Rev A)
Page 22 of 42
Parts Required
Item
Part Number
Description
Qty
1
8754-870900-41
BRACKET,MOUNTING ASM,EX25,CK75
1
1
8754-870900-43
BRACKET,MOUNTING ASM,N5603,CK75
1
Removal
1. Remove the bottom housing assembly (refer to Bottom Housing operation).
2. Disconnect the scan switch/speaker harness from the main logic board.
3. Using a T7 torx driver remove 4 screws that secure the scan bracket to the core assembly.
4. Gently lift the scan bracket away from the core assembly and disconnect the antenna coax from J4 on the main logic
board.
5. Disconnect the scan engine and camera flex cables from the main logic board.
The scan bracket assembly can now be serviced itself or set aside to be re-installed later. If the base scan bracket assembly
is being replaced you will remove the WAN/WiFi antenna, EA30 scan engine, camera, and side scan PCB’s and transfer
them to the replacement base scan bracket assembly. See the EA30 Scan Engine, WAN/WiFi Antenna, Camera, and Side
Scan PCB operations elsewhere in this guide for tool, parts, & procedures related specifically to those items.
Scan switch/speaker
harness connector
1
802.11
antenna coax
connector at J4
Camera flex
cable
connection
Scanner
flex cable
connection