Honeywell CN100 - Dimensions and Layouts

ATTENTION: ESD HAZARD
Electrostatic discharge can damage integrated circuits or
semiconductors if you touch connector pins or tracks on a
printed wiring board.
l Touch a grounded object to eliminate static electricity
l Wear an approved anti-static wrist strap
l Do not touch the wire connectors or connector pins
l Do not touch circuit components inside a component
l Use a static-safe workstation if available
l Leave the component in its static shielding box or bag until
they are ready for installation.
ATTENTION: Unless the location is known to be non-hazardous,
do not:
l Connect or disconnect cables
l Install or remove components
While the control system is powered.
ATTENTION: A moins que vous soyez dans une zone
d’atmosphère non explosive, ne pas:
l Connecter or déconnecter les câbles
l Installer or retirer des composants du système
Lorsque le système de contrôle est sous tension.
Dimensions and Layouts
In this section:
Dimensions of Redundant CN100 Controller 21
Installation Dimensions for a Redundant Controller 23
20
Chapter 4 - CN100 Platform Installation