Honeywell CN51 - Status Leds and Indicators

Chapter 2 — Printer Basics
PrintPAD Series CN70/70e & CN51 User Guide 5
Status LEDs and Indicators
Printer LEDs: Use this illustration to reference the location of the printer LEDs.
Power LED
Radio LED
Battery Status LED
Power LEDs
Battery LED Status Description Action
Red (solid)
The battery has less than
5% power.
• If AC power is not plugged in, the printer will soon turn
off.
• If the AC power is plugged in, the LED flashes and
charging is in progress.
• Charge the battery.
• None. Wait for the charge
LED to turn green.
Orange (solid)
The battery has less than
25% power.
• If AC power is not plugged in, the battery charge is low.
• If AC power is plugged in, the LED flashes and
charging is in progress.
• Charge the battery.
• None. Wait for the charge
LED to turn green.
Green (solid)
The battery is near or at full
capacity
• If AC power is not plugged in, the battery is well
charged.
• If AC power is plugged in, the LED is solid and
charging is complete.
• None.
Red to orange flash – fast
• Battery voltage is too high. • Replace battery.
Orange flash – slow
• Charge has timed out. • Restart battery charge
(battery may be bad).
Orange flash – fast
• Internal code error. • Remove the battery, then
reconnect AC power.
Orange, red, or green
flash – fast
• When AC power is plugged into the printer’s power
port, the battery status LED flashes orange, red, or
green (depending on the battery status) to indicate the
AC adapter is plugged in.
• None.
Audio Indicators
Beeps Description Action
1 Printer wakes up. None.
2 Out of paper. Install paper.
3 Low battery. Charge battery.
1 short RF power is on (when blue, RF power button is pressed
and power was turned off).
None.
2 short RF power is off (when blue, RF power button is pressed
and power was turned on).
None.