2 - 7
Attach the Sled to the Belt Clip
Attach the Headset (Optional)
1. Align the sled assembly with the belt clip and press on the sled until it latches
onto the belt clip. Be sure to align tabs on the back of sled with the notches on
the belt clip.
2. Slide the clip over a belt to wear the assembly.
1. Make sure the audio jack door is open as shown in the previous section.
2. Slide the 3.5mm audio connector into the end cap.
3. Attach the quick disconnect end of the headset adapter cable to the
headset’s cable.
To Next Page
Loading...
