4 - 1
4
Using the Ring Scanner and Headset
Overview
The 8620 ring scanner is a wearable external image engine that connects to the Dolphin 75e Wearable Solution. It reads
popular 1D and 2D bar codes and supports omni-directional aiming and decoding for greater flexibility in real-world settings.
Note: This document describes the 8620 model ring scanner only. If you are using a different model, use Revision A of this
document. For the 8620, the model number is located on the product label See Required Safety Labels on page A-3.
Decoding Bar Codes
Once the ring scanner is connected, you must run ScanWedge NGW (page 4-2) and have an application able to receive
scanned data open before your scanner will be able to scan. The lighting and aimer will not turn on when you press the trigger
until ScanWedge NGW and a data capture ready application are running on the terminal.
Note: You can change this behavoir by specifying applications on the Blacklist, see ScanWedgeNGW.exm Sections on page 4-
3.
Aiming Beam
When scanning bar codes, place the aimer over the bar code to be read.
Linear Bar Code.
2D Matrix Symbol
Warning: Do not stare directly in to the laser beam
To Next Page
Loading...
