Honeywell Gamewell 7100 Series - Table 5-2 Sensor Sensitivity Settings

9000-0447 Rev. I
Page 29 of 42
[SET ] 1: Verification 2: Sensitivity
[DEFAULTS] 3: PAS 4: Multilevel
1: Opens Set Default Verify Options Menu.
2: Opens Set Default Sensitivity Menu.
3: Opens Set PAS Parameters Menu.
Main
Config
Global
Device defaults
4: Opens Set Multilevel Parameters Menu.
[DFLT ] 1: Dflt Ion, Photo Verify (None)
[VERIFY] 2: Dflt Manual Sta Verify (None)
1: Scrolls through None, Smoke, PAS.
Main
Global
ConfigDevice defaults
Default Verification
2: Toggles between None and PAS.
[DFLT] DAY 1: Photo (Low) 2: Ion (Low)
[SENS] NIT 3: Photo (Med.) 4: Ion (Med.)
1: Scrolls through selections for photo sensor daytime
sensitivity.
2: As above for Ion.
3: As above for photo night time sensitivity.
Main
Config
Global
Device Defaults
Default Sensitivity
4: As above for Ion.
[PAS ] 1: Night Bypass (ON)
[OPTION] T1 (15sec) T2 (180sec)
1: Toggles Night Bypass ON/OFF.
Main
Config
Global
Device Defaults
PAS Parameters
T1 and T2 parameters are fixed in firmware; they are shown
for reference only.
[MULTI] 1: Alert Threshold (35%)
[LEVEL] 2: Action Threshold (65%)
1: Scrolls through Alert Threshold options (20, 35, 50, 65%)
2: Scrolls through Action Threshold options (35, 50, 65, 80%)
Main
Config
Global
Device defaults
Multilevel Params
OK: accepts settings as shown (if valid)
[NAC ] 1:Delay Times
[OPTIONS] 2: Coding & Silencing
1: Opens Set NAC Delays Menu.
Main
Config
Global
NACs
2: Opens Set NAC Coding Menu.
[NAC ] 1: Silence Inhibit (None)
[DELY] 2: Cutoff (None)
1: Scrolls through Silence Inhibit Delay options (None, 1 min,
3 min, 5 min)
Main
Config
Global
NACs
Delay Times
2: Scrolls through Signal Cutoff Delay options (None, 5 min,
10 min, 15 min)
[NAC ] NAC 1 1: (Coded) 3: (Silenceable)
[MISC] NAC 2 2: (Steady) 4: (Nonsilenceable)
1: Toggles NAC 1 between Coded and Steady.
2: Toggles NAC 2 between Coded and Steady.
3: Toggles NAC 1 between Silenceable and Non-silenceable.
Main
Config
Global
NACs
Coding
4: Toggles NAC 2 between Silenceable and Non-silenceable.
Table 5-2 Sensor Sensitivity Settings
Photo Ion
Low 2.0 1.3
L/M 1.75 1.2
Med. 1.5 1.0
M/H 1.25 0.88
High 1.0 0.77