Need help?Do you have a question about the Honeywell Granit 1980i and is the answer not in the manual?
General| Product color | Black, Red |
|---|---|
| Housing material | - |
| International Protection (IP) code | IP65 |
| Type | Handheld bar code reader |
| Scanner type | 1D/2D |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | -30 - 50 °C |
| Operating relative humidity (H-H) | 0 - 95 % |
| Power source type | DC |
| Power consumption (standby) | 0.5 W |
| Power consumption (typical) | 2.35 W |
| Standard interfaces | USB |
| Connectivity technology | Wired |
| Harmonized System (HS) code | 84716070 |
Weight and Dimensions| Depth | 133 mm |
|---|---|
| Width | 75 mm |
| Height | 195 mm |
| Weight | 335 g |
Guidance on connecting the scanner to a host device via various interfaces.
Configuration for connecting the scanner as a keyboard wedge to IBM PC AT systems.
Instructions for connecting the scanner via a PC or terminal serial port.
Steps to establish a wireless link between the scanner and its charging base.
Procedure for establishing a wireless link between the scanner and an Access Point.
Configuration of beeper and LED feedback for good reads and error conditions.
Selection and configuration of different trigger modes for scanner operation.
Step-by-step guide to adding custom prefixes or suffixes to scanned data.
Guide on creating and saving custom data formats for specific symbologies.
Settings for Code 128, including ISBT concatenation, redundancy, and message length.
Configuration for UPC-A symbology, including check digit, number system, and addenda.
Command to capture an image using hardware trigger or software command.
Command to transmit captured images to the host system.
Resets scanner to original factory settings, disabling plugins.
Restores scanner settings to custom defaults or factory defaults if none exist.
Guide to diagnosing and resolving issues with corded scanners.
Steps for diagnosing and resolving issues specific to cordless scanners.
A comprehensive chart of bar codes used for programming scanner settings.
To Next Page
