Honeywell GSMV4G User Manual

GSMV4G/GSMVCN4G Installation and Setup Guide
3-10
Alternative Mode Programming
Press the [ENTER] key to begin programming and follow the prompts for the mode of
operation being programmed.
NOTE: The central station can remotely block access to local
device programming. If this has been done, the following
prompt appears:
Access to Prog
Mode Denied
Table 3-4. Programming for Zone Trigger, 4204 Emulation, or Two-4204 Emulation modes.
PROMPTS
ZONE
TRIG.
4204/
2-4204
OPTIONS DESCRIPTION
1
Strt Prog Mode?
(Y/N)_
X X
[Y], [N]
Enters programming mode.
2
Enter Password
X X
[0-9, A-F, N, S,
T, X, Y]
If a password has been previously assigned, this
prompt appears. Enter a 4-digit password (0-9, A-F,
N, S, T, X, Y).
The next prompt appears.
3
Program Device?
(Y/N)_
X X
[Y], [N]
To begin programming the communicator, press [Y]
and go to Prompt 9: "Device Mode."
To create a password if none has been assigned,
press [N] and go to Prompt 4: "Create Password."
To change an existing password, press [N] and go to
Prompt 5: "Change Password."
4
Create Password?
(Y/N)_
X X
[Y], [N]
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program Device?"
prompt.
If a password is desired, press [Y] and go to Prompt
6: "Enter Password."
5
Change Password ?
(Y/N)
X X
[Y], [N]
If a password has already been assigned, this
prompt appears after pressing [N] at the "Program
Device?" prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key
when prompted for the new password and its
confirmation.
6
Enter Password
X X
[0-9, A-F, N, S,
T, X, Y]
If [Y] was pressed in Prompt 4 or 5, this prompt
appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
7
Verify Password
X X
[0-9, A-F, N, S,
T, X, Y]
Re-enter the password as confirmation.
If the password doesn't match the first entry, the
following is displayed followed by the "Exit Prog.
Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is
displayed directly.
8
Exit Prog. Mode?
(Y/N)_
X X
[Y], [N]
[ESC]
Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode paragraph
in this Section.

Honeywell GSMV4G Specifications

General

Brand	Honeywell
Model	GSMV4G
Category	Cell Phone
Language	English