Honeywell GSMV4G - GSM Status Displays

GSMV4G/GSMVCN4G Installation and Setup Guide
5-2
GSM Status Displays
[E]
Operating with 3G/4G service
PriRSSI 3/4G REG
-xxxdbm stat x
Status Display Screen 1
PriRSSI – Primary site RSSI level in dBm.
3/4G – Communicator is on the 3G/4G network where
“stat” can be:
Good
RSSI
–20 to –90 dBm
OK
RSSI
–91 to –99 dBm
Marginal
RSSI
–100 to –105 dBm
Bad
RSSI
–106 to –150 dBm
REG – Registration status where “x” can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the last screen.
RAT Ec/N0
3G/4G -xxxxx
Status Display Screen 2
RAT – Radio Access Technology.
Ec/N0 – Carrier Noise Ratio (CNR)
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Cntry Netw LAC
xxx xxx xxxxx
Status Display Screen 3
Cntry – Country Code
Netw – Network Code
LAC – Local area code
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Cell Chan PSC
xxxxxxx xxxx xxx
Status Display Screen 4
Cell – Base Station ID
Chan – Control Channel in use
PSC – Primary Sync Code
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
Second Site RSSI
Available
Status Display Screen 5
Secondary Site RSSI availability. Available or Not
Available will be displayed.
Press the [space] key to go to Status Display Screen 1.
Press the [backspace] key to go to the previous field.