4-1
SECTION 4
Registration
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Registering the Communicator
Once you have initialized and programmed the communicator, it must be registered to
enable the account. The registration status is indicated below:
(green)
ON – Is NOT registered with AlarmNet.
OFF – Is registered with AlarmNet.
MESSAGE
(yellow)
ON – Message transmission pending.
QUICK PERIODIC BLINK - Normal
SLOW BLINK – In unison with green LED,
Registration in progress.
FAULT
OFF – No fault present.
Upon completion of the registration process, the communicator transmits a registration
message and receives a registration validation indicating that the account is now enabled.
Wait for the "Registration Success" message to appear, regardless of which registration
method used.
You can register the communicator by one of the following methods:
• Through the AlarmNet Direct website
• Through use of the Tamper Switch
• Through use of a 7720P Programming Tool
• By phone
Registering through AlarmNet Direct Website
The communicator can be registered through the AlarmNet Direct Website. To program the
communicator via the website (if you are already signed up for this service), go to:
https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx.
Log in and follow the on-screen prompts.
If you are not signed up for this service, click on “Dealer Signup” from the login screen to
gain access to the Honeywell web-based programming.
Dealer Sign-Up Direct Link: https://services.alarmnet.com/AlarmNetDirectP_Sign-Up.
You will be instructed how to proceed upon completing the sign-up form. Only one sign-up
per dealer is required. Once an initial user is established, additional logins may be created
by that user.
NOTE: Central Stations sign up by contacting AlarmNet Administration at 800-222-6525
option 3.
Please have the following information available when programming the device:
• Primary City ID (two-digit number)
To Next Page
Loading...
Need help?
General
