Honeywell GSMV4G - Page 43

Section 5: Programmer Keyboard Commands
5-3
[E]
Operating with 2G service
PriRSSI 2G REG
-xxxdbm stat x
Status Display Screen 1
PriRSSI – Primary site level in dBm.
2G – Communicator is on the2G network where “stat”
can be:
Good
RSSI
–20 to –89 dBm
OK
RSSI
–90 to –98 dBm
Marginal
RSSI
–99 to –104 dBm
Bad
RSSI
–105 to –150 dBm
REG – Registration status where “x” can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the last screen.
RAT Ec/N0
2G NA
Status Display Screen 2
RAT – Radio Access Technology.
Ec/N0 – Carrier Noise Ratio (CNR). This is not a 2G
parameter, therefore, NA is displayed.
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Cntry Netw LAC
xxx xxx xxxxx
Status Display Screen 3
Cntry – Country Code
Netw – Network Code
LAC – Local area code
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Cell BaseSt Chan
xxxx xxxx xxx
Status Display Screen 4
Cell – Base Station ID
BaseSt – Base Station Antenna Sector
Chan – Control Channel in use
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
Second Site RSSI
Available
Status Display Screen 5
Secondary Site RSSI availability. Available or Not
Available will be displayed.
Press the [space] key to go to Status Display Screen 1.
Press the [backspace] key to go to the previous field.