Appendix
Technical Data
27
Error message Cause / Remedy
LIVING
No entries exist. In-
sert?
NO YES
In this example the "LIVING" module does not have
any entries.
► Confirm correspondingly.
!
Faulty signal of an external sensor.
► Check where the signal comes from as de-
scribed in the operating instructions of the sen-
sor.
► Check the batteries.
► Improve the transfer conditions as described in
the operating instructions of the sensor.
WIND
or
CAUTION!
Wind function is
active!
The wind protection is active. The setpoint cannot
be changed at the respective modules. The function
is de-activated automatically when the wind force
has not exceeded the threshold for 20 minutes.
Faults
Fault Cause / Remedy
The temperature in a
room is controlled
incorrectly
The radio connection in the Hometronic system
may be faulty.
► Check the fault display at the storey controller
and at the HR 50.
No display at the
display
The power supply is interrupted.
► Check the power supply.
Functioning of the
Hometronic Manager
is not possible or
only to a limited
extent
► Call the Service Department or bring the device
to the After-Sales. Inform the After-Sales of the
software version number which you noted in the
operating instructions.
To Next Page
Loading...
