Honeywell
27
Manual Record
Live Viewing
After you have logged in, the system is in live viewing mode. You can see
the system date, time and channel name. If you want to change the system
date and time, you can refer to general settings (Main
MenuSettingGeneral). If you want to modify the channel name, refer
to the display settings (Main MenuSettingDisplay).
1
Recording status
3
Video loss
2
Motion detection
4
Camera lock
Note
Live audio will only be played under the single channel
video display mode.
Manual Record
Note
You need to have proper rights to implement the following
operations. Please make sure the HDD has been properly
installed.
Manual Record Menu
There are two ways for you to go to the manual record menu.
Right-click the mouse to select Record, or in the main menu proceed
to AdvancedManual Record.
In live viewing mode, press the ● key on the front panel or on the
remote control.
Manual record menu is shown in Figure 4-5.
Basic Operations
There are three modes: schedule/manual/stop. Please highlight icon”○” to
select the corresponding channel.
To Next Page
Loading...
