Honeywell
67
After rebooting, DVR will connect to the internet automatically. The IP in the
PPPoE is the DVR dynamic value. You can access this IP to visit the unit.
Figure 5-11 PPPOE Setup Menu
NTP Setup
You need to install SNTP server (Such as Absolute Time Server) in your
PC first. In Windows XP OS, you can use the command “net start w32time”
to boot up NTP service.
NTP setup interface is shown in Figure 5-12.
Host IP: Input your PC address.
Port: This series DVR supports TCP transmission only. Port default
value is 123.
Update interval: Minimum value is 1. Max value is 65535. (Unit: minute)
Time zone: Select your corresponding time zone here.
Here is a chart for your time zone setup.
City/Region Name Time Zone
London GMT+0
Berlin GMT+1
Cairo GMT+2
Moscow GMT+3
New Deli GMT+5
Bangkok GMT+7
Beijing (Hong Kong) GMT+8
Tokyo GMT+9
To Next Page
Loading...
