BCU 580 · Edition 11.15l 114
OCU
14 OCU
14.1 Application
The OCU is an external operator-control unit which
can be connected to a control unit of the FCU 500/
BCU 500 series. The external operator-control unit
OCU may be installed in the door of a control cabinet,
for example. Thus, the control cabinet does not need to
be opened to read out process values, statistics, flame
signal intensities or parameter values, to change set-
tings on the OCU or to control or adjust connected but-
terfly valves in Manual mode.
To Next Page
Loading...
