BCU 580 · Edition 11.15l 6
Application
Using the BCSoft program, the parameters, analysis
and diagnostic information can be read from a BCU
via the optionally available opto-adapter. All valid
parameters are saved on an integrated parameter chip
card. The parameter chip card can be removed from
the old unit and inserted into a new BCU to transfer the
parameters, for example when replacing the unit.
The monitored outputs for the actuator and valves are
accommodated in a plug-in power module. This can
simply be replaced if necessary.
Once the plug-in power module has been removed, the param-
eter chip card and fuses are accessible.
The BCU can be installed on a DIN rail in the control
cabinet. Plug-in connection terminal strips on the BCU
make it easier to install and remove.
Thanks to the operator-control unit OCU, display functions and
operation of the BCU can be relocated to the control cabinet
door.
To Next Page
Loading...
