Honeywell LYNX Touch - Page 19

– 19 –
SECURING THE PREMISES
SECURING THE PREMISESSECURING THE PREMISES
SECURING THE PREMISES
Arming the System
➂ ➃ ➄ ❼ ❾ ➘ ➴ ➷ ❽ ❿
➬ ➮ ➱ ✃❐ ❒ ❮ ❐ ❰ Ï Ð Ñ Ò Ó Ô ❰ Õ Ö ❒ ❐ ❒
➵ ➸ ➸ ➸ ➺ ➻ ➸ ➸ ➺ ➸ ➵ × ➺ ➾ ➸
Ø ➮ Ù ✃ Ú
➬ ✃ Ú Ú Û Ü ✃
Ý Þ
Ú ß ✃ à
á â Ú Û ➱ à ã ä
➮ Ù ✃
3. At the end of the exit delay the system
will announce
➶
Armed Stay
➹
and
display the
➚
Armed Stay
➪
screen.
■ ◗ ❅ ❍ ❉ ❍ ❚ ❅ ❏ ❉ ● å ❈ Ô ❊ ❋ Ò ● Ô ❉ ❈ Ô ❍ Ó Ô ❊ Ô ● P Ó ❃ Ô ❈ ❇ ❈ Ó Ô ▲ ◆ ❉ ❏ ❏ ❊ Ô Ó ▼ ❊ ❍ Ó Ò Ó ❃ Ô ❃ Ò ▲ Ô ❈ ❑ ❊ Ô Ô ❍ ❖
Auto Stay Feature
If this feature is enabled by installer, the LYNX Touch SIA, when armed AWAY from the control’s
keypad or a Wireless Keypad, switches to the STAY mode if the Exit Time expires and no exit has been
made.
NOTE: If the exit route entry/exit sensor is in a check condition or has been bypassed it will result in a loss of interior
protection because the alarm system will arm STAY in this case. Consult with your installer for servicing of the
entry exit zones or to turn off this feature if a check condition on entry exit zones occurs.