Chapter 6 — Printer Maintenance
58 MP Nova Mark II User Guide
Printhead Replacement
1 Make sure the printer is turned off and open the cover.
2 Check and remember the current lateral position of the printhead; 3 mm
(0.12 in.) is the default position.
3 Carefully push the printhead downward until the finger nut becomes visible.
Unscrew the finger nut.
Note: The pictures shown describe an MP Nova4 DT. The process is the same
for all MP Nova printers.
Note: Only adjustable on the MP Nova4 DT printer.
Note: Take care not to lose the finger nut.
To Next Page
Loading...
Need help?
General