What to do if Honeywell Barcode Reader scans but the data transmitted to the host is incorrect?
Verify that the scanner’s data format matches that required by the host and that the scanner is connected to the proper host port. The scanner’s data format may not match the host system requirements.
What to do if Honeywell ms2420 Barcode Reader powers up OK and scans OK but does not communicate properly to the host?
Check to make sure that the baud rate and parity of the scanner and the communication port match and the program is looking for RS232 data. The com port at the host may not be working or is not configured properly.
What to do if Honeywell Barcode Reader scans a bar code, but locks up after the first scan?
If the scanner is setup to support ACK/NAK, RTS/CTS, XON/XOFF or D/E, verify that the host cable and host are supporting the handshaking properly. The scanner may be configured to support some form of host handshaking but is not receiving the signal.
What to do if Honeywell ms2420 beeps at some bar codes but NOT for others of the same bar code symbology?
There are several potential reasons for this issue: * The bar code may have been printed incorrectly. Check if it is a check digit, character or border problem. * The scanner is not configured correctly for this type of bar code. Check if check digits are set properly. * The minimum symbol length setting does not work with the bar code. Check if the correct minimum symbol length is set.
How to fix multiple scans upon presentation of code on Honeywell Barcode Reader?
Adjust same symbol timeout for a longer time. The same symbol timeout may be set to short.
What to do if Honeywell ms2420 unit powers up but does not beep?
There are a few possible reasons: * The beeper is disabled. Enable the beeper. * No volume is selected. Select a volume. * No tone is selected. Select a tone.
Why Honeywell ms2420 has no LEDs, beep or motor spin?
Check the transformer, outlet and the power strip. Make sure the power cable is plugged into the scanner. The reason for this is that no power is being supplied to the scanner.
Why Honeywell Barcode Reader has no LEDs and no beep?
Use the power supply included with the scanner. The host system cannot supply enough current to power the MS2420 series scanner.
What to do if Honeywell ms2420 drops characters?
Add some intercharacter delay to the transmitted output by using the MetroSelect Configuration Guide (PN 00-02407x). The intercharacter delay needs to be added to the transmitted output.
What to do if Honeywell ms2420 Barcode Reader secondary scanner powers up but data is not relayed to the host?
Ensure that the secondary scanner is connected to the MS2420 com port marked “Aux” port. Also, the MS2420 series must be configured to enable the auxiliary port. The secondary scanner cable may not be connected to the proper port on the MS2420, or the auxiliary com port may not be operating properly.
General| Connectivity | Wired |
|---|---|
| Connectivity Technology | USB |
| Scan Pattern | Single Line |
| Interface | USB |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Humidity | 5% to 95% relative humidity (non-condensing) |
To Next Page
