Cable Installation (Interface Specific)
RS232
9. Turn on the host system.
10. Scan the Recall Defaults bar code.
Note: The Recall Defaults bar code is located in the MetroSelect Configuration Guide, under Need to
Start Over (PN 00-02407x).
11. Configure the scanner to match the host system’s RS232 parameters.
Note: Refer to the MetroSelect Configuration Guide (PN 00-02407x) under Section G: RS232 for
enabling RS232 Mode (scan the recall defaults bar code first).
Refer to the MS2x20 Stratos Series Scanner/Diva Scale Configuration Addendum
(PN 00-02272x) for scale, dual cable and single cable configuration bar codes.
xx** Specifies international connection. See the Base Kit Components and Optional Accessories section of this
guide for a complete listing.
See power source caution statement on page 13 of this manual.
Figure 19. RS232 Interface Cable Installation Schematic
To Next Page
Loading...
