Why Honeywell Barcode Reader has multiple scans upon presentation of code?
If the Honeywell Barcode Reader has multiple scans upon presentation of code, adjust the same symbol timeout for a longer time, as it may be set too short.
Why Honeywell MS2431 Barcode Reader beeps at some bar codes and not for others?
If the Honeywell Barcode Reader beeps for some bar codes but not others of the same type, the print quality of the bar code may be poor. The type of printer or its settings could be the problem. Check the print mode or change the printer settings; for example, change to econo mode or high speed.
Why Honeywell Barcode Reader powers up but does not beep?
If the Honeywell Barcode Reader powers up but doesn't beep, the beeper may be disabled, so enable the beeper. Alternatively, no volume or tone may be selected, so select a volume and a tone.
Why Honeywell Barcode Reader doesn't scan and/or beep?
The Honeywell Barcode Reader may not scan or beep because it's trying to scan a symbology that isn't enabled. UPC/EAN and Code 128 are enabled by default, so verify that the type of bar code being read has been selected. Also, the unit might be configured for a character length lock or a minimum length, and the bar code being scanned doesn't meet the criteria. Verify that the bar code falls into the configured criteria; the scanner defaults to a minimum of 4 characters for non-UPC/EAN codes.
What to do if characters are being dropped by Honeywell MS2431?
If characters are being dropped by the Honeywell Barcode Reader, the intercharacter delay may need to be added to the transmitted output.
What to do if the host is receiving data from Honeywell MS2431 but the data does not look correct?
If the host receives data from the Honeywell Barcode Reader but it doesn't look correct, check that the scanner and the host are configured for the same interface.
What to do if Honeywell Barcode Reader scans a bar code, but locks up after the first scan?
If the Honeywell Barcode Reader scans a bar code but locks up after the first scan, it may be configured to support host handshaking but isn't receiving the signal. If the scanner is set up for ACK/NAK, RTS/CTS, XON/XOFF, or D/E, verify that the host cable and host support handshaking properly.
Why Honeywell MS2431 locks up after scanning once?
General| Interface | USB |
|---|---|
| Scan Pattern | Area Image |
| Operating Temperature | 32°F to 122°F (0°C to 50°C) |
| Storage Temperature | -40°C to 60°C (-40°F to 140°F) |
| Drop Specification | 1.8 m (6 ft) to concrete |
To Next Page